Buy Airlink AWLH5025 MIMO XR 802.11g Wireless PCI Adapter: Accessories - Amazon.com. Drivers on the CD are borked, they'll BSOD on install (Windows).

• MIMO XR™ 802.11g PCI Adapter Model # AWLH5025 User’s Manual Ver. 3 1.1 Package Contents. 4 2.1 Install Driver & Utility.

4 2.2 Verify Driver Installation. Configure the Wireless PCI Adapter. Configure the Wireless Utility.

15 4.1 Link Information. 15 4.2 AP List. Introduction Thank you for purchasing the MIMO XR™ Wireless PCI Adapter.

When used with other Airlink101™ MIMO XR™ wireless products, the wireless signal range extends farther than standard 802.11g products. This Adapter supports 64/128-bit WEP data encryption that protects your wireless network from eavesdropping.

Installation 2.1 Install Driver & Utility This section provides instructions on how to install the MIMO XR™ Wireless PCI Adapter. The driver is installed along with the utility. Note: Be sure to turn off your computer before inserting the Adapter. For Windows 98SE and ME users, you may be prompted to insert the Windows 98SE or ME CD during the driver installation. • Step 3 The Autorun screen will pop up. Select Install Utility from the menu.

Note: If the Autorun screen doesn’t appear automatically go to Start, Run, and type D: autorun.exe (where D is the letter of your CD drive) and click OK. Step 4 Click Next at the welcome screen. • Step 5 Click Next to accept the default destination folder. Step 6 Click Continue Anyway at the Windows Logo Screen. (For Windows 2000, click Yes at the Digital Signature Not Found prompt).

Adobe free pdf download. • Step 7 Verify Yes, I want to restart my computer now is selected and click Finish to restart your computer. • 2.2 Verify Driver Installation To verify if the driver has been installed successfully, please perform the following steps.

Step 1 Right-click on My Computer from your desktop and select Properties. Step 2 Select the Device Manager tab. (For Windows 2000/XP, select the Hardware tab first then click on Device Manager). • Expand Network adapters from the list and verify that Airlink101 MIMO XR PCI Adapter is listed and no yellow question mark is beside it. If Airlink101 MIMO XR PCI Adapter is not listed, or you see a yellow question mark beside it, please re-install the driver again.

Configure the Wireless PCI Adapter This section describes how to connect your MIMO XR™ Wireless PCI Adapter to a wireless network. Note to Windows XP Users: You must disable the Wireless Zero Configuration Utility in order to use the bundled Wireless Utility. • To open the Wireless PCI Adapter’s utility go to Start > (All) Programs > Airlink101 MIMO PCI Utility > Airlink101 MIMO PCI Utility. Step 1 Go to the AP List tab, select the SSID (Network Name) of the wireless network. • Step 2 If encryption is not enabled for the selected access point / router, skip to step 6. Otherwise, enter a Profile Name for your wireless setting and click Next. Step 3 Verify that the Network Name matches the SSID of your wireless network and click Next.

• Step 4 Select the proper encryption setting for your wireless router or access point from the drop-down menu and click Next. Step 5 Follow the on-screen instructions to complete the encryption settings. Click Complete when finished.

Step 6 You should see a blue circle around the antenna icon indicating a valid connection. • Step 7 Go to the Link Information tab and click on the More button. Step 8 Verify that you are receiving adequate Signal Strength and Link Quality and that you have been assigned a valid IP address (instead of all 0’s). If you do not have adequate Signal Strength, try re-orienting the Access Point and/or the Wireless PCI Adapter to get a better reception.